The fiberglass sleeving for carbon brush is a non-alkali fiberglass braided sleeivg coated with adhesive. It possesses excellent flexibility and smooth cut. It can be used as a cover for the pigtail of a carbon brush.
|
|
|
|
| Specifications︰ |
| Bore Diameter |
Wall Thickness |
| Nominal |
Tolerance （±） |
Minimum |
Maximum |
| 1.0，1.5，2.0，2.5，3.0 |
±0.20 |
0.15 |
0.75 |
| 3.5，4.0，5.0，6.0，7.0，8.0，9.0 |
±0.25 |
0.20 |
0.75 |
| 10.0，12.0，14.0 |
±1.00 |
0.40 |
0.75 |
|
| Advantages︰ | Appearance: the sleeving is not sticky. There are no lines and blots on the surface but small pellets may appear due to glass thread sleeving. It`s colour is black or dark, and no any clear sigh of discolouration.
Heat resistance: When it cools down after being kept in a box with a constant temperature of 130±2℃ for 24hours and is wound around the specific mandrel, it`s coating will not crack.
Twist resistance: When the sleeving is cut and the new ned is twisted ten times by fingers, the crosscut will not get loose by two inter-section of braid.
Compatibility of wire`s colour: The colour of the wire inserted inside the sleeving should be compatible with the colour which was uninserted.
Length: 1000+20-10㎜(Continusus length may bengotiated)
|
|
|
|
